CM-9S SPECIFICATIONS
polymer blending

I. FEATURES
  1. INLET - 4" 150#flg (end)
  2. OUTLET - 4" 150#flg (rt angle to inlet, at 90 deg intervals)
  3. WEIGHT - 750 US lbs.
  4. HEAT JACKET
  5. BEARING COOLING JACKET
  6. GAP ADJUSTING COLLAR (running or idle)
  7. ELECTRONIC LUBRICATOR
  8. MAINTENANCE FREE MECHANICAL SHAFT SEAL
  9. BEARING TEMPERATURE GAUGES
  10. SHAFT, ROTOR AND COUPLING BALANCED
  11. SHOP RUN TESTED
II. OPTIONS
  1. CLOSED LOOP COOLING SYSTEM
  2. SPECIAL ABRASION PLATES
  3. DIGITAL BEARING TEMP INDICATORS
  4. DISCHARGE HIGH PRESSURE SWITCH
  5. COOLING WATER TEMP REGULATOR
III. CAPACITIES
  1. POLYMER BLENDING
    • Single pass; 10,000 gph@4-16%
    • Multiple pass; 30,000 gph
  2. EMULSIFICATION (NOT RECOMMENDED)
IV. PRESSURE
  1. INLET: 20-100 psi
  2. OUTLET: 10-50 psi
V. POWER
  1. 250 to 300 hp, tefc, 3000/3600 rpm motor
Back to Homepage